Table of Contents
Advertisement
First start
▀
The boiler is only roughly set from the factory. Before first start an easier tuning must be done.
Then the boiler can be started and the combustion can be controlled and fine tuned with a flue
gas analyzer. After a couple of week in service, a check of the flue gas values should be done.
The values shown in the menues earlier are good for a startup of the boiler. Then
fine tuning is needed.
Tuning the boiler.
▀
Start with the settings by entering the boilers menu (page 17.).
Temperature settings
►
The start and stop temperatures for the burner is set in the menue "TEMPERATURE
SETT." The start temperature should not be set below 75°C, there might be problem
with hot water running out. This is of course depending on which boiler being used.
Temperature el.heater
►
Set the temperature for the electrical heater to start if there would accure a fault or the
pellet should run out. Set the temperature 5-10°C below the burners start temperature.
Cleaning of tubes
►
Set the time when the cleaning of the tubes should be activated.
Clock
►
In this menu, the same as "Cleaning", the time is set. If there is a power outage, unfor-
tunately the clock has to be set again.
Shunt
►
Set the desired indoor temperature. Do this by turning the room thermostat. There is
no value on the knob, the value is changed on the display on the boiler. The thermostat
should be placed in an open space without interferences by heat from e.g a stove or
cold draft. Sometimes the heating system might need to be trimmed by turning the ther-
mostats on the radiators in different rooms.
►
El. heater
Here you set what effect the electrical heater should have if activated. You can choose
3 or 6kW, or both. If both is set to active the effect will be 9000W. Remember to check
that the fuses in the house can handle the power to the electrical heater.
22
Effecta AB Västra Rågdalsvägen 21 434 99 Kungsbacka Sweden +46-300 - 22320 info@effecta.se
Advertisement
Table of Contents
