Table of Contents
Advertisement
▀
Shunt control
In the menu "shunt control" there are different options of controls; indoor sensor, outdoor
sensor or both in combination.
Room sensor
If the room sensor is used it is recommended to be installed in a open space near the center
of the house. The sensor shouldn´t be interfered by draught, doors, sunlight directly to it or
other heat sources since it then will block the entire heating output to the house.
6
Connected to number 3 on the main board
2
Not used
Outdoor sensor
If a outdoor sensor is used this should be mounted on the facad of the house. It is important
the sensor is mounted on the north side of the house. Make sure that the sensor isn´t
disturbed from solar insolation. It is recommended that the sensor is mounted about 2 metres
from ground level and if possible protected from water and such.
1
Connected to 1 on the main board
2
Connected to 2 on the main board
Effecta AB Västra Rågdalsvägen 21 434 99 Kungsbacka Sweden +46-300 - 22320 info@effecta.se
Loosen the control wheel by
pulling outwards. The loosen
the screw to open the box.
4
1
Loosen the screw and split the
casing. It is then possible to
mount the box to the wall.
Connected to number 5 on the main board
Connected to number 4 on the main board
25
Advertisement
Table of Contents
