Setting The Feed Bracket To The Front Position; Switching Between Single-Pedal And Dual-Pedal Operation - Brother DH4-B981 Instruction Manual

7-5. Setting the feed bracket to the front position

Setting the material will be easier if the feed bracket is moved forward from the standard cloth setting position.
* Cycle time will be reduced with this setting, particularly if cutting after sewing is selected.
0928Q

7-6. Switching between single-pedal and dual-pedal operation

The work clamp can be lowered and the machine can start sewing just by pressing the start switch, without having to
use the cloth presser switch.
0928Q
0939Q
1 2 3 4 5 6 7 8
OFF
q
0941Q
1 2 3 4 5 6 7 8
OFF
q
DH4-B981
1. Turn off the power.
2. Set DIP switch C No. 2 on the control circuit board to
2. ON.
3. Turn on the power.
4. Press the start switch q.
5. The feed bracket will move to the home position and
5. then to the front position.
6. Sewing can then be carried out as normal. (Refer to
6. page 44.)
1. Turn off the power.
2. Change the setting of DIP switch C No. 1 on the control
2. circuit board.
2. OFF: To use both pedals (cloth presser switch and
2. OFF: start switch)
2. ON: To use only one pedal (start switch)
3. Turn on the power and press the start switch q.
4. Move the feed bracket to the cloth setting position.
5. Sewing can then be carried out as normal. (Refer to
5. page 44.)
NOTE:
During single pedal operation, when the start switch is
pressed, the work clamp is lowered and sewing starts
straight away.
5. If you would like to reset the material, set to dual-pedal
5. operation.
7. SEWING
47