Setting The Taper Bar Tacking Length; Setting The Knife Operation Method; Setting The Eyelet Shape - Brother DH4-B981 Instruction Manual

C. Setting the taper bar tacking length
A
1 2 3 4 5 6 7 8
OFF
0910Q
D. Setting the knife operation method
B
1 2 3 4 5 6 7 8
OFF
0911Q
E. Setting the eyelet shape
1 2 3 5
B
1 2 3 4 5 6 7 8
OFF
No. 6 No. 7 No. 8 Taper bar tacking length
ON
0 mm
OFF OFF
ON
4 mm
OFF OFF
ON ON
5 mm
OFF
6 mm
OFF OFF OFF
ON
7 mm
OFF OFF
ON ON
8 mm
OFF
ON ON
9 mm
OFF
ON ON ON
10 mm
No. 1 Knife operation method
ON
Cutting before sewing
Cutting after sewing
OFF
No. 2 No. 3 Eyelet shape (knife no.)
ON
Eyelet hole (No. 1)
OFF
Eyelet hole (No. 2)
OFF OFF
ON
Eyelet hole (No. 3)
OFF
ON ON
Straight hole (No. 5)
1. Turn off the power.
2. The taper bar tacking length can be set to between
2. 4 - 10 mm.
3. Set to 0 mm for no taper bar tacking. At this time, the
3. offset value is ignored.
4. Change the settings for panel DIP switch A No. 6, No.
4. 7 and No. 8 to set the desired taper bar tacking length.
5. Turn on the power.
1. Turn off the power.
2. For cutting before sewing, the knife operates before
2. the buttonhole is sewn. For cutting after sewing, the
2. knife operates after the buttonhole is sewn.
3. Change the setting for panel DIP switch B No. 1 to set
3. the desired knife operation method.
4. Turn on the power.
1. Turn off the power.
2. The eyelet shape can be selected from four types of
2. cutting shape.
2. * Knife No. 2 is normally installed. Select the number
2. * for the eyelet shape that matches the number of the
2. * installed knife.
3. Change the settings for panel DIP switch B No. 2 and
3. No. 3 to set the desired knife operation method.
4. Turn on the power.
0912Q
DH4-B981
6. USING THE OPERATION PANEL
35