Brother DH4-B981 Instruction Manual page 35

<-52 specifications>
t
q
0891Q
1. Place the material (fly) on top of the feed bracket q, and then feed the material (fly) in until it reaches horizontal
cloth set guide (L) w and horizontal cloth set guide (R) e.
1.
* Check that the right edge of the material (fly) is straight against the left edge of the vertical cloth set guide r at
this time.
2. The vertical sewing margin can be adjusted between 9 - 21 mm for L1 - L4 and 9 - 11 mm for L5 - L7.
Loosen the four screws t, and then move horizontal cloth set guide (L) w and horizontal cloth set guide (R) e
forward or back to adjust.
3. The horizontal sewing margin can be adjusted between 30 - 40 mm.
Loosen the two screws y, and move the vertical cloth set guide r to the left or right to adjust.
3.
Cloth setting position
Left setting position
0893Q
The sewing start position can be set to either the left setting position or the horizontal setting position. (Refer to page
37.)
When set to the left setting position
This is the normal setting position for the cloth.
* After the last buttonhole is sewn, the cloth feed bar returns to the left setting position.
Horizontal setting position
The cloth is set to both the left setting position and right setting position.
* The next piece of cloth is set at the position that the last buttonhole was sewn.
w
e
r
y
t
DH4-B981
5. CORRECT USE
30 - 40 mm
Right setting position
0892Q
9 - 21 mm for
L1 - L4
9 - 11 mm for
L5 - L7
0894Q
29