Daewoo KORANDO Service Manual page 279

1B2-90 M161 ENGINE MECHANICAL
Tools Required
001 589 72 21 00 Torqued Wrench
000 589 04 14 00 Clamping Strap
Removal Procedure
1. Unscrew the connecting rod bolt (3) and remove the cap.
2. Remove the connecting rod and the piston upward.
Notice
Make sure that the bearing cap and shell are not changed
each other.
3. Remove the snap ring (5) and pull out the piston pin (6).
Notice
Remove the snap ring using a clean cloth as shown in the
right picture so that the piston, piston ring, and the snap
ring don't get damaged.
Installation Procedure