Daewoo KORANDO Service Manual page 229

1B2-40 M161 ENGINE MECHANICAL
6. Remove the in take camshaft sprocket (E20 engine).
7. Remove the camshaft adjuster (E23, M161.973 engine).
Installation Notice (Flange Bolt)
Tightening Torque
Notice
The flange bolt is designed to be used only once, so always
replace with new one.
8. Remove the guide rail pin using the sliding hammer (02)
and the threaded pin (03).
Notice
Apply the sealant on guide rail pin when installation.
9. Unscrew the bolts (A).
Installation Notice
Tightening Torque
1st step 18 - 22 Nm
2nd step 85° - 95°
22.5 - 27.5 Nm
Bolt (A) : (M8 X 35, 4 pieces)
1 Flange Shaft
2 Flange Bolt
3 Campression Spring
4 Adjust Piston
5 Camshaft Sprocket
6 Seal Cover
7 Nut