A Configure Your Dsl Modem - Medialink MWN-WAPR150N User Manual

2.2a Configure Your DSL Modem To
Bridged Mode
(For ADSL Virtual Dial-Up via PPPoE Users Only)
If you were not successful in setting up the router after
Section 2.2 – continue with the additional instructions below:
1. Disconnect Your Medialink Router
a.Remove the network cable that is plugged into
b.Remove the network cable that is plugged into
c. Remove the power cable from the back of the
2. Connect Your DSL Modem Directly To
Computer –
a.Using a network cable, plug one end in to the
b.Plug the other end into the computer's network
3. Confirm Access To The Internet.
a.If you can access the internet, proceed to step
b.If you cannot access the internet:
the yellow port of the router (if applicable).
the blue "WAN" port of the router.
router.
network port of your DSL Modem.
port
i. Power down your DSL Modem and
your computer (remove the power
35
MWN-WAPR150N Wireless Router v3.0
A