A Configure Your Dsl Modem; Bridged Mode - Medialink MWN-WAPR150N User Manual

2.2a Configure Your DSL Modem To

Bridged Mode

(For ADSL Virtual Dial-Up via PPPoE Users Only)
If you were not successful in setting up the router after
Section 2.2 – continue with the additional instructions below:
1. Disconnect Your Medialink Router
2. Connect Your DSL Modem Directly To
Computer –
3. Confirm Access To The Internet.
a. Remove the network cable that is plugged into
the yellow port of the router (if applicable).
b. Remove the network cable that is plugged into
the blue "WAN" port of the router.
c. Remove the power cable from the back of the
router.
a. Using a network cable, plug one end in to the
network port of your DSL Modem.
b. Plug the other end into the computer's network
port
a. If you can access the internet, proceed to step
b. If you cannot access the internet:
i.
MWN-WAPR150N Wireless Router v3.0
Power down your DSL Modem and
your computer (remove the power
35
A