Medialink MWN-WAPR150N User Manual page 43

9. "Bridged Mode" might be called "Transparent Bridge
Mode", or "1483 Transparent Bridged Mode".
10. Once the modem is set to Bridged, it will reboot. At
this point your computer will no longer have access
to the internet.
11. Remove the network cable that is plugged into your
computer and your DSL Modem.
12. Connect Your Medialink Router (Figure 2.1)
a. Plug a network cable from your DSL modem
into your Medialink Router's Blue WAN Port.
b. Using another network cable, plug one end
to your computer's network port. Plug the
other end into one of the Medialink Router's
yellow ports numbered 1, 2, 3, or 4. (It is
not required to connect a computer to the
router at this point.
recommended for faster setup of your
wireless network. Once setup is complete,
you may then unplug the computer and
connect wirelessly.)
c. Power On your Medialink Router - Connect the
AC/DC Adapter to the router's Power port.
Connect the other end into an electrical
outlet. Wait 30 seconds to allow
MWN-WAPR150N Wireless Router v3.0
But it is highly
38