Chapter 4 - Jumper Settings; Jumper Settings - System Board; Clear Cmos Data - DFI EC200 Series User Manual

Chapter 4 - Jumper Settings

Jumper Settings - System Board

Clear CMOS Data

If you encounter the following,
a) CMOS data becomes corrupted.
b) You forgot the supervisor or user password.
you can reconfi gure the system with the default values stored in the ROM BIOS.
To load the default values stored in the ROM BIOS, please follow the steps below.
1. Power-off the system and unplug the power cord.
2. Set JP8 pins 2 and 3 to On. Wait for a few seconds and set JP1 back to its
default setting, pins 1 and 2 On.
3. Now plug the power cord and power-on the system.
Jumper Settings
1 2 3
JP8
1-2 On:
Normal (default)
1 2 3
2-3 On:
Clear CMOS Data
4
53