Table of Contents
Advertisement
If smoke, odors or noise rise from the device, turn off the power at once and unplug the power cable, and then please contact
•
the service center.
If the product does not work properly, please contact your dealer or the nearest service center. Never attempt to disassemble
•
the speed dome yourself. (We shall not assume any responsibility for problems caused by unauthorized repair or
maintenance.)
Cautions
Do not drop the dome or subject it to physical shock, and do not expose it to high electromagnetism radiation. Avoid the
•
equipment installation on vibrations surface or places subject to shock (ignorance can cause equipment damage).
Do not place the dome in extremely hot, cold, dusty or damp locations, otherwise fire or electrical shock will occur. The
•
operating temperature should be -22 °F ~ 149 °F (-30 °C ~ 65 °C).
The dome cover for indoor use shall be kept from rain and moisture.
•
Exposing the equipment to direct sun light, low ventilation or heat source such as heater or radiator is forbidden (ignorance can
•
cause fire danger).
Do not aim the speed dome at the sun or extra bright places. A blooming or smear may occur otherwise (which is not a
•
malfunction however), and affecting the endurance of sensor at the same time.
Please use the provided glove when open up the dome cover, avoid direct contact with the dome cover, because the acidic
•
sweat of the fingers may erode the surface coating of the dome cover.
Please use a soft and dry cloth when clean inside and outside surfaces of the dome cover, do not use alkaline detergents.
•
Please keep all packaging for future use. In case of a failure, use the original packaging to return the camera to the factory.
•
Transportation without the original packaging may result in damage to the camera and incur additional costs.
Read these instructions and keep them in a safe place for future reference.
Please refer all work related to the installation of this product to qualified service personnel or system installers.
•
Do not operate the camera outside of its specified temperature, humidity or power source ratings.
•
Install the unit away from heat sources such as radiators, heat registers and stoves.
•
Installation of the unit near consumer electronics devices, such as stereo receiver/amplifiers and televisions, is permitted as
•
long as the air surrounding the terminal does not exceed the above mentioned temperature range.
Handle the camera with care. Do not drop or shake, as this may damage it.
•
Do not use strong or abrasive detergents when cleaning the surfaces of this product. When dirt is hard to remove, use a mild
•
detergent and wipe gently.
Save your system configuration.
•
Distributing, copying, disassembling, reverse compiling, reverse engineering, and exporting, in violation of export laws, the
•
software provided with this product is expressly prohibited.
iv
Advertisement
Table of Contents
