Table of Contents
Advertisement
SECTION 2: INSTALLATION
4. Plug the power cable provided (not shown) into the back of the injector, then into a standard 120 Vac electrical outlet. When
power is applied to the injector, the camera will power on and a system information display will appear for 2 minutes on top of
the live video image from the camera. Verify that the information on the display is intelligible.
Power cables
The power drop cables are used to provide 24 Vac power to the camera. Refer to "APPENDIX C 24 Vac Wire Gauge and Transmission
Distance" on page 29 for more information.
When power is applied to the injector, the camera will power on and a system information display will appear for 2 minutes on top
of the live video image from the camera. Verify that the information on the display is intelligible (see above).
If the camera is powered through the LAN cable using a PoE injector, application of power through this cable is optional.
16
Typical System Information display
Advertisement
Table of Contents
