Camera Wall Mount Installation - ALIBI ALI-IPZ5030T Installation Manual

Insert SD card into the ALI-IPZ5030T camera
1. Open the lower dome to access the dome drive.
2. Find the SD card slot near the camera lens.
3. Insert the SD card (up to 32 GB) until it is fully seated.
4. Reattach the lower dome.
Insert SD card into the ALI-IPZ5030RT camera
1. Use a Phillips #2 screw driver to remove the SD card slot cover, located on the back of the dome drive.
2. Insert the SD card (up to 32 GB) until it is fully seated.
3. Reattach the SD card slot cover.

2.3 Camera wall mount installation

Following the instructions below to install the camera using the ALI-PTZWB Wall Mount Bracket.
Instructions for mounting the camera with a ALI-PTZPM Pole Mount PTZ Bracket or ALI-PTZCM Corner Mount PTZ
Bracket are very similar. For these brackets, use the instructions below as a guide.
1. Determine the best mounting screws and hardware to anchor the mounting bracket with the camera to the mounting surface.
Use the following guidelines:
For cement wall mounting, use the expansion screw to anchor the bracket.
—
For wooden wall mounting, use self-tapping screw to anchor the bracket.
—
Make sure that the wall is strong enough to withstand more than 8 times the weight of the camera and the bracket.
—
2. Using the mounting bracket as a template, mark the location of the mounting screw holes on the mounting surface. Also mark
the location of a hole for the camera drop cable. The drop cable will be routed through the mounting bracket and through the
mounting surface.
3. Drill holes in the mounting screws and hardware. Also, drill a 1½" diameter hole in the mounting surface for the drop cable.
4. Apply two wrap of the thread tape provided onto the treads of the pendant adapter (see below)
ALI-IPZ5030 Series IP PTZ Camera Installation Guide
SECTION 2: INSTALLATION
11