Table of Contents
Advertisement
Connect the Audio Out and ground wires to a line level audio receiver (impedance 600 Ω).
Alarm inputs can be either normally open (N.O.) or normally closed (N.C.), configurable in the camera firmware.
RS-485 cables
Connect the RS-485 drop cable wires to an RS-485 or, or DVR/NVR with an RS-485 network interface for control of PTZ features.
PTZ features can also be controlled through the camera network (browser) interface, and through a supported NVR PTZ control
panel. These wires are color coded and labeled.
Video cables
The video drop cable provides a BNC connector with a composite NTSC signal for connection to any compatible monitor. The feature
is useful for maintenance and for showing the live view display on a local monitor.
Network (LAN) cable
Connect the network LAN drop cable to a router (switch) through an Ethernet drop cable. In some network configurations, the LAN
cable can connect directly to a Network Video Recorder (NVR) with a built-in network switch.
The LAN cable can also provide Hi-PoE to the camera. A Hi-PoE injector is provided for powering mode. A typical PoE injector is
shown below.
Injector status LEDs
Port labeling
To use the injector:
1. Connect the injector ground wire to an earth ground terminal. (NOTE: Not all PoE injectors have a ground wire.)
2. Connect a LAN drop cable between the network switch and the DATA IN port on the injector.
3. Connect a LAN drop cable between the injector DATA and POWER OUT port and the camera LAN drop cable.
LAN cables for
DATA IN (to network switch) and
DATA and POWER OUT (to camera)
ALI-IPZ5030 Series IP PTZ Camera Installation Guide
SECTION 2: INSTALLATION
Ground wire
15
Advertisement
Table of Contents
