ALI-IPU3030RV IP Bullet Camera
Quick Installation Guide
This document guides you through the basic steps to install and configure the ALI-IPU3030RV cameras. The
ALI-IPU3030RV camera features:
3 MP high resolution sensor
•
2.8 - 12 mm vari-focal lens
•
Full 1080P HD real-time video with H.264 compression
•
IR LEDs with illumination up to 100 feet
•
3D-DNR noise reduction, Wide Dynamic Range (WDR), Backlight compensation
•
Dual power capable - Power over Ethernet (PoE) or 12 Vdc
•
Weatherproof - IP66 rated and Vandalproof - IK10 rated
•
Internal MicroSD card storage up to 64GB (card not provided)
•
Audio I/O, Alarm I/O
•
For more information about the software features of this camera, please refer to the ALI-IP Camera
Software User Manual.
Articulated
mounting
bracket
Camera body
IR array
Lens
Wide - Tele and Near - Far adjustment levers
Camera with sun shield and lens cover removed
Camera base
locator pins
Top (up)
Bottom (down)
Conduit port (2)
Junction box detail
www.observint.com
1
Junction box assembly
(see detail below)
Camera mounting base
Sun Shield
Lens cover
Reset button
SD card slot
Video test cable connector
Mounting screw
hole (4)
Hole for camera
mounting screw (3)
Cable access
through mounting
surface
What's in the box
Your camera includes the items below.
Video test
cable
Weatherproof
LAN coupling
Surface
mount drill
template
Step 1.
Install the camera
The camera includes hardware to install it directly to a mounting surface or to the Junction box provided.
The camera can be installed on a ceiling (horizontal surface) or wall (vertical surface). To install the camera,
do one of the following:
To mount the camera directly onto a mounting surface
Mounting screw hole
1.
Determine the best fasteners for securing the camera to mounting surface. The mounting hardware
provided is suitable for most surfaces.
2.
Using the Drill Template provided, mark the location of the mounting screw holes. If mounting the
camera onto a vertical surface, orient the Drill Template so it is vertical, as shown in the photo above.
If the drop cable will be routed through the mounting surface, mark the location of the hole for the
camera drop cables. NOTE: The camera drop cables can also be routed through the opening in the
edge of the camera mounting base.
3.
Drill holes for the mounting fasteners, and for the drop cables where needed.
4.
Route the network LAN, power, and ALARM and AUDIO peripheral cables to the installation location.
5.
Continue the installation with Connect camera drop cables to peripherals, LAN and power
below.
To mount the camera using the Junction box
1.
Using the Junction box as a template, mark the location of the Junction box mounting screw holes.
If routing cables for the LAN, power, and the alarm and audio peripherals through the mounting
surface, mark the location for that hole too. NOTE: If installing the box onto a vertical surface in a
location subject to moisture, observe the orientation for TOP and BOTTOM marked inside the box.
Security
L-wrench
CD-ROM
manuals and
software
Mounting
hardware
packet
Junction box
(top view)
Wall insert (3)
Course-thread
Mounting screw (3)
ALI-IPV3030RV_CQ
10/23/14