ALIBI ALI-IPV3030RV Quick Installation Manual

ALI-IPV3030RV IP Dome Camera

Quick Installation Guide

This document guides you through the basic steps to install and configure the ALI-IPV3030RV cameras. The
ALI-IPV3030RV camera features:
3MP high resolution sensor
•
2.8 - 12 mm vari-focal lens
•
HD real-time video with H.264 compression
•
IR LEDs with illumination up to 65 feet
•
3D-DNR noise reduction, Wide Dynamic Range (WDR), Backlight compensation
•
Dual power capable - Power over Ethernet (PoE) or 12 Vdc
•
Weatherproof - IP66 rated and Vandalproof - IK10 rated
•
Internal micro-SD card storage up to 64GB (card not provided)
•
Audio I/O, Alarm I/O
•
Available Wall Mount Bracket (ALI-IPV31WB)
•
Available Junction Box (ALI-IPV31JB) for Wall Mount Bracket (ALI-IPV31WB)
•
For more information about the software features of this camera, please refer to the ALI-IP Camera
Software User Manual.
Lower
dome
assembly
Dome
assembly
IR array
Lens
Drop cable for
power and LAN
Conduit
port
Lower
dome
assembly
Drop
cables
Lens
IR LED
array
Reset
button
MicroSD
card slot
Video test
monitor
cable
connector
Camera gimbal
tilt pivot point
Camera with dome cover removed
www.observint.com
1
Drop cable for
peripherals
Holes for
mounting
screws (3)
Product label
Wide (W) /Tele (t)
zoom control
Near (N) / Far (F)
focus control
Mounting
screw
holes (3)
Dome
screw
holes (3)
Dome
tether
What's in the box
Your camera includes this document and the items shown below.
Video test
cable
Weatherproof
LAN coupling
Surface
mount drill
template
Step 1. Install the camera
The camera includes hardware to install it directly to a mounting surface, or onto a single- or double-gang
electrical box using the gang box adapter plate shown above. Camera drop cables can be routed through
the conduit port on the side of the lower dome, through the mounting surface or into an electrical box, if
used. To install the camera:
1. Remove the dome assembly by loosening the three captive dome screws using the security
L-wrench provided.
2. Install a MicroSD card in the SD card slot, if needed.
3. To mount the camera, do one of the following:
To mount the camera directly onto a mounting surface
1. Determine the best fasteners
for securing the camera
to mounting surface. The
mounting hardware provided is
suitable for most surfaces.
2. Using the Drill Template
provided, mark the location of
the mounting screw holes. If
the drop cable will be routed
through the mounting surface,
mark the location of the hole for
the camera drop cables.
3. Drill holes for the mounting
fasteners, and for the drop cable
where needed.
4. Continue the installation with
Connect camera drop cables
to peripherals, LAN and
power below.
To mount the camera onto an electrical box
1. Install a single- or double-gang electrical box at the location where the camera will be installed.
2. Secure the flat side of the gang box adapter plate to the open side of the box using appropriate
screws.
Continue the installation with Connect camera drop cables to peripherals, LAN and power
3.
below.
Security
L-wrench
CD-ROM
manuals and
software
Mounting
hardware
packet
Gang box
adapter plate
(camera side
shown
Mounting
screw hole
Wall insert
Drop
cables
Lower
dome
assembly
Mounting
screws
ALI-IPV3030RV_CQ
5/16/14