OPTIONAL HITCH
Installation of Optional Hitch - Current Wheel Motor Cover Plates
Before installing or servicing the optional hitch make sure the Traxx engine is off, the battery
is disconnected and the Traxx unit is on a flat and stable surface.
To install hitch on the unit first slide hitch in to rear
square tube frame as shown. Line up holes of hitch with
holes of the pre-drilled holes on unit frame as shown.
Refer to images Asm-RC-0002, ASM-RC-0003 and
Asm-RC-0004.
Once aligned insert 2 socket head bolts, 2 flatwashers
and 2 nuts and tighten loosely on one side. Go to the
opposite side and insert 2 bolts, 2 flatwashers and 2
nuts to that side and do the same.
If hitch is aligned and looks properly installed proceed to
torque the bolts to 202 ft. pounds and apply torque seal.
Refer to image Asm-RC-0006
Make sure to get help when installing hitch to unit by either having someone else help or
using a hoist. Hitch is heavy and serious injury can occur.
TRAXX RF 04/14
© 2014 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-5