Air Filter Cleaning And Replacement; Support Springs - Alamo Industrial Traxx RF Operator's Manual

AIR FILTER CLEANING AND REPLACEMENT

The procedure for cleaning or replacing the air filter is as follows:
1. Release two hooks and carefully remove the air filter cover. (Step 1)
2. Remove the outer air filter element. (Step 2)
3. Remove the inner air filter element. (Step 3)
4. If the air filter cartridges are very dirty or damaged, they must be replaced.
5. Before replacing the air filter cartridges clean carefully inside the filter box as well as the filter cover.
6. Mount the air filter cover and attach with hooks.
7. Check for debris in the external drain.
NOTE: Do not wash the air filter cartridge. Do not use solvents. Do not oil the cartridge.

SUPPORT SPRINGS

The hydraulic rams that position the front mounted flailhead are equipped with support springs. The support
pressure offered by the springs can be adjusted to suit differing needs and applications by altering their work
position tension.
The procedure for adjusting the springs is as
follows;
• Raise the flailhead fully by operation of the
hydraulic rams.
• Remove bolt and washer from the ram rod end
and release the chain from the lug.
• Re-attach the chain selecting an alternative link
to either increase or decrease tension.
• Replace washer and bolt to secure in position.
• Repeat the process on the opposite ram.
TRAXX RF 04/14
© 2014 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-17