System Id Number; Directory Digits; Change The Welcome Message - PACH & COMPANY AeGIS 8000 Series Installation And Programming Manual

FUNCTION CODE
08

SYSTEM ID NUMBER

(DEFAULT SETTING IS =1 )
09

DIRECTORY DIGITS

(DEFAULT SETTING IS=3)
Directory is used to identify a tenant name. It
must be unique for every tenant. The directory
code is used for direct dialing (see system
operation) and to modify and delete the existing
tenants.
Directory digit must be selected before to do any
programming. If 3-digit directory code is
selected, you must use 3-digit directory code for
all tenant.
10

CHANGE THE WELCOME MESSAGE

(DEFAULT SETTING IS
(" Welcome to Pach's Telephone Access
System")
The welcome message consists of three
segments. Each segment is 16 characters long.
Pach and Company
AeGIS 8000 Series
Not applicable, do not change the default setting.
Step 1 Log on to programming mode, see instruction above. The display
will show
Select Func: _ _
Step 2 Enter function code 09 then press #, the display will show
DIR DIGITS: 3
Step 3 Enter the directory digits 2, 3 or 4 then press # or press * to keep
the current setting.
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
programming mode and you will hear " three short beeps".
Step 1 Log on to programming mode, see instruction above. The display
will show
Select Func: _ _
Step 2 Enter function code 10 then press #, the display will show
Welcome to Pach'
Step 3 Press * to erase the current message then enter a new one using
the keypad (press # every character you have entered) then press
## after the last character you have entered to proceed to the 2 nd
segment, the display will show
s Telephone Acce
Step 4 Press * to erase the current message then enter a new one using
the keypad (press # every character you have entered) then press
## after the last character you have entered to proceed to the 3 rd
segment, the display will show
ss System ... **
Step 5 Press * to erase the current message then enter a new one using
the keypad (press # every character you have entered) then press
## after the last character you have entered.
Step 6 Proceed to step 2 and select the same function code or different
function code to continue programming or press
programming mode and you will hear " three short beeps".
Chapter 3
PROGRAMMING
PROGRAMMING
1 st segment
2 nd segment
3 rd segment
to exit the
*
to exit the
*
Page 12