Relay 1 (Door 1) Remote Access Number Selection; Relay 2 (Door 2) Remote Access Number Selection; Master Code Mask; Verify Model And Firmware Version - PACH & COMPANY AeGIS 8000 Series Installation And Programming Manual

FUNCTION CODE
20
RELAY 1 (DOOR 1) REMOTE ACCESS
NUMBER SELECTION
(Default setting is 9)
Remote access number is used for all tenants to
provide remote access to their visitor(s). This
number can be changed. The AeGIS 8000
Series have two relay, the second relay remote
access number is set for number 8. If you
change the remote access programming on
relay 1 to a different number, do not select
number 8, if you do so, the second relay cannot
be released using the 8.
21
RELAY 2 (DOOR 2) REMOTE ACCESS
NUMBER SELECTION
(Default setting is 8)
Remote access number is used for all tenants to
provide remote access to their visitor(s). This
number can be changed. The AeGIS 8000
Series have two relay, the first relay remote
access number is set for number 9. If you
change the remote access programming on
relay 2 to a different number, do not select
number 9, if you do so, the second relay cannot
be released using the 9.
40

MASTER CODE MASK

(Default setting is 0 for UNMASK)
MASK: Master code cannot be retrieved using
the master code retrieve button. If you
forget the master code, you must
purchase a new memory chip.
UNMASK: Master code can be retrieved using
the master code retrieve button.
46

VERIFY MODEL AND FIRMWARE VERSION

Pach and Company
AeGIS 8000 Series
Step 1 Log on to programming mode, see instruction above. The display
will show
Select Func: _ _
Step 2 Enter function code 20 then press #, the display will show
OpenDoor1 No: 9
Step 3 Enter 1-9 then press #.
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
programming mode and you will hear " three short beeps".
Step 1 Log on to programming mode, see instruction above. The display
will show
Select Func: _ _
Step 2 Enter function code 21 then press #, the display will show
OpenDoor2 No: 8
Step 3 Enter 1-9 then press #.
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
programming mode and you will hear " three short beeps".
Step 1 Log on to programming mode, see instruction above. The display
will show
Select Func: _ _
Step 2 Enter function code 40 then press #, the display will show
MC_MASK 1=YES: 0
Step 3 Enter • 1 = MASK
• 0 = UNMASK
then press #
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
programming mode and you will hear " three short beeps".
Step 1 Log on to programming mode, see instruction above. The display
will show
Select Func: _ _
Step 2 Enter function code 46 then press #, the display will show
V :XXXXA MM/DD/YY
Chapter 3
PROGRAMMING
PROGRAMMING
to exit the
*
to exit the
*
to exit the
*
Page 15