Table of Contents
Advertisement
FUNCTION CODE
06
SYSTEM ID
(Default setting is 0)
07
REMOTE ENABLE/DISABLE
(Default setting is Enabled)
Set the function code to ENABLE if
the management software is used to
program the system. If the function
code is set to DISABLE, the system
will not answer an incoming call.
08
RELAY 2 MODE
(Default setting is as DOOR.
CONTROL)
MODE1: DOOR CONTROL
MODE 2: A SHUNT
MODE 3: AN ALARM TIMER
MODE 4: A CCTV V SWITCH
See Chapter 4. System's
Operation for more detail
explanation.
Pach and Company
AeGIS NPB9000P Series
Step 4 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Do not change the programming, leave the value as default. The function code is
not used.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 07 then press # and the display shows
Step 3 Enter 1 to ENABLE and 0 to DISABLE then press #, the display shows
Step 4 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 08 then press # and the display shows
Step 3 Enter
1- DOOR CONTROL
2- A SHUNT
3- AN ALARM TIMER
4- A CCTV SWITCH
then press #, the display shows
Step 4 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Chapter 3
PROGRAMMING
LOCAL PROGRAMMING
Page 12
06/20/11
Advertisement
Table of Contents
