Advertisement
TOTAL NUMBER OF TENANT DIRECTORY
Number of tenants are occupied the system memory
Chapter 4
SYSTEM'S OPERATION
A. How to view tenant's directory
B. How to initiate a call from the system
C. How to release the door remotely
D. How to make a call to an extension or
voice mail
E. How to extend talk time
AeGIS 7000V
91
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 91 then press #
Total TnT: 025
2. The display above is shown the total number
of tenant's directory is 2
1. Press
(scroll A-Z) or
2. Press
(scroll Z-A)
Two ways to initiate a call
1. By scrolling (see A, press 3 or 6 to scroll)
then press # to call
2. By directory, press # (wait for dial tone) then
press the tenant's directory number.
NOTE: VISITOR MUST KNOW THE TENANT'S
DIRECTORY NUMBER
1. Establish a communication
2. Tenant must press 9 to release the door.
ALTHOUGH, THE SYSTEM IS TESTED
WITH MOST PHONES, COMPATIBILITY ISSUE
MAY STILL BE OCCURRED, ESPECIALLY WITH
VOICE OVER IP (VOIP) PHONE.
PULSE PHONE WILL NOT WORK
1. Established a communication
2. Press the voice mail or extension number
using the system's keypad.
Talk time is set using function code 70 (10-180
seconds), see p18.
1. Establish a communication
Page 21
Advertisement
