Edit An Existing Tenant - PACH & COMPANY AeGIS 8000 Series Installation And Programming Manual

FUNCTION CODE
02

EDIT AN EXISTING TENANT

The directory code must be available to edit an
existing tenant directory. If the directory code is
not available, see function code 78 to retrieve it
or use software to edit it. NOTE: Function code
78 cannot retrieve a directory code without a
name.
Pach and Company
AeGIS 8000 Series
• Press 2 once times for letter A then press #
• Press 2 three times for letter C then press #
• Press 4 twice for letter H then press #
• Press 0 for space then
• Press 1 eleven times for 1 then press #
• Press 1 twelve times for 2 then press ## then the display will
show
PH #: _ _ _ _ _ _ _ _ _ _ _
Step 5 Enter the tenant phone number or extension number up to 11-digit
then press #, the display will show
ACCESS CODE:_ _ _ _
Step 6 Enter the 4-digit access code then press #. The access code is
the code for the tenant to gain access. If you use one access
code for all tenant you only need to enter once into one of the
tenant directory.
Step 7 Proceed to step 2 and select the same function code or different
function code to continue programming or press
programming mode and you will hear " three short beeps".
Step 1 Log on to programming mode, see instruction above. The display
will show
Select Func: _ _
Step 2 Enter function code 02 then #, the display will show
Modify Dir: _ _ _
Step 3 Enter the directory code to be modified the press #, the display
will show
Enter the NAME:
then the display will show
current name show here
Step 4 • To change the name do the following:
• Press * and program a new tenant name
• Press # after entering each character then
• Press ## after entering last character.
• To keep the name press #
The display will show
PH#:current phone number
Step 5 • To change the phone number press * and program a new one
the press #.
• To keep the phone number press #
The display will show
Chapter 3
PROGRAMMING
PROGRAMMING
to exit the
*
Page 9