Control Panel; Buttons - Digital Projection M-Vision Cine 320 Series Installation And Quick Start Manual

Digital Projection
M-Vision Cine 320 Series

Control panel

The projector control panel is designed to be read from the front or rear of the
projector, for ease of use.

Buttons

•
Arrows, and
SELECT MENU
Use these buttons to navigate the projector menus.
•
POWER
Press to switch the projector on, press again to switch to STANDBY
mode.
•
SOURCE
Cycle through the inputs, in the following order:
HDMI 1, HDMI 2, RGB, Composite 1, Composite 2, Video, S-Video,
HDMI 1...
The projector will automatically adjust to an active signal, and display it.
Otherwise it will continue searching through the inputs until it finds a valid
signal.
Rev D July 2014
PROJECTOR OVERVIEW
MENU
POWER
ISSUE
LED STATUS
Installation and Quick-Start Guide
Notes
For full details of how to use the
controls and the menu system, see
SOURCE
the Operating Guide.
POWER
5