Brightness, Contrast, Saturation, Hue, Sharpness, Noise Reduction; Overscan - Digital Projection M-Vision Cine 320 Series Installation And Quick Start Manual

Digital Projection
M-Vision Cine 320 Series

Brightness, Contrast, Saturation, Hue, Sharpness, Noise Reduction

These settings use a slider (Fig. 1).
To adjust any of these settings:
1. Highglight the setting you wish to select.
2. Press LEFT or RIGHT once to open the slider.
3. Use the LEFT and RIGHT arrow buttons to adjust the value from 0 to
200:
4. To return to the Main menu, press

Overscan

This setting, if switched on, removes unwanted artefacts from the edges of
your image by cropping the edges or increasing the size of the image to force
the edges off-screen.
Unwanted artefacts along the image edges usually occur when the projector
is connected to a low quality input souce..
Use the and arrow buttons to select from:
LEFT RIGHT
•
Off
•
Crop
Blanks a 3% border from the left and right edges of the image.
•
Zoom
Increases the horizontal and vertical resolution of the displayed image by
6%, so that the all four edges fall outside the screen area.
Rev D July 2014
.
MENU
A TOUR OF THE MENUS
Fig. 1 Brightness slider
Operating Guide
Notes
Decrease Saturation if the colors
appear too bright; increase it if the
colors appear muted or washed out.
Decrease to shift the hue
Hue
toward red; increase it to shift the
hue toward green.
31