Trigger 1 And Trigger 2; Auto Source - Digital Projection M-Vision Cine 320 Series Installation And Quick Start Manual

Digital Projection
M-Vision Cine 320 Series

Trigger 1 and Trigger 2

The Trigger 1 and Trigger 2 outputs are interchangeable:
Screen trigger can be connected to an electrically operated screen, automatically deploying the screen when the projector starts
up, and retracting the screen when the projector shuts down.
Aspect Ratio trigger can be used to control screen shuttering for different aspect ratios.
For each Trigger setting, use the LEFT
Screen
trigger occurs when the projector is in RUNNING mode.
16:9 trigger occurs when 16:9 aspect ratio is selected.
Theaterscope
trigger occurs when Theaterscope aspect ratio is selected.
4:3 trigger occurs when 4:3 aspect ratio is selected.
4:3 Narrow
trigger occurs when 4:3 Narrow aspect ratio is selected
RS232 trigger output follows the On or Off setting specified in a trig.1 or trig.2 command received from a PC via the
RS232 serial input.

Auto Source

Use the and arrow buttons to select from:
LEFT RIGHT
On
The projector searches for an alternative input source when the current input is disconnected.
Off The projector shows a "blank" screen when the current input is disconnected.
Rev D July 2014
and RIGHT arrow buttons to select from:
A TOUR OF THE MENUS Operating Guide
Notes
To set what a 'blank' screen looks
like, use the Blank Screen setting
in the System menu.
42