Table of Contents
Advertisement
Installing Wall-Mount (MXD) Panels
6.
When the first side is free, repeat the process with the other.
7.
With the edge of the touch panel free, carefully lift up and out (Landscape) or to the left and out (Portrait) to remove
the touch panel from the Backbox. Be careful not to pull on the cables or connectors.
8.
To reattach the panel to its Backbox, repeat the installation procedure.
For further information, refer to the video available at www.amx.com (go to
Newsroom > Videos > Touch Panels).
MXD-1000/ MXD-700 Installation
Refer to A Note About Wall and Rack Installation on page 45 for important notes
on thermal concerns with Wall and Rack Installations.
Note that the figures in this section show landscape (-L) panels, but the concepts presented here apply equally to portrait
(-P) panels, since the hardware is the same for landscape and portrait panels except for the horizontal / vertical
orientation. Detailed specifications drawings for the
www.amx.com.
MXD-1000 and MXD-700 panels may be installed directly into a solid surface, using either solid surface screws or the
included locking tabs for different mounting options.
Once installed, the panel is contained within a clear outer housing known as the Backbox (FIG. 36). This Backbox is
removed to install the device into a wall or when using the optional Rough-In Box accessory (FG039-17).
FIG. 36
MXD-1000 and MXD-700 Backboxes (Landscape orientation)
For typical mounting surfaces, such as drywall, use the locking tabs as the primary
method for securing the Backbox to the surface. For thin walls or solid surfaces, use
mounting screws (not included).
56
MXD-1000
Locking tabs
Locking tabs
MXD-1000
and
MXD-700
are available to download from
Locking tab
Locking tab
MXD-700
Modero X® Series G4 Touch Panels Instruction Manual
Advertisement
Table of Contents
