Table of Contents
Advertisement
2.
When the images begin to display, touch any place on the touchscreen to open the configuration popup menu
(FIG. 5).
Random / A-Z
Previous image
FIG. 5
Picture View Configuration Popup Menu
If no selection is made, this menu will remain in place for 15 seconds and then disappear. It may be accessed again
by touching anywhere on the touchscreen.
3.
On the leftmost amber button, select between Rand (images display at random) and A-Z (images display in
alphabetical order based on the name of the file).
4.
The four gray buttons allow scrolling through saved images and the rate of display:
The Previous Image Saved button returns the display to the first image uploaded by Page View.
The Stop button stops Page View and returns to the default panel page.
The Pause/Resume button allows the display to stop on one particular image. Press it again to resume the
display procession.
The Next Image Saved button returns the display to the last image uploaded by Page View. If the panel has
not accessed all of the images available on a USB drive, Page View will display the last one uploaded to date.
5.
On the rightmost red button, select the number of seconds a selected image will be displayed in Picture View. This
may be selected between 5, 10, 15, 30, and 60 seconds.
6.
The counter beneath the buttons displays the number of images currently uploaded by the panel, versus the number
detected on the USB drive.
Preview Mode and Normal Mode
Picture View has two modes: Preview Mode and Normal Mode. Preview Mode allows the user to configure Picture View.
Once a USB drive containing images is inserted into the panel, the images will begin to display. Touching any place on
the display will result in the configuration popup to slide from the bottom of the display.
Picture View goes into its Normal Mode when the panel goes into idle timeout while connected to a USB drive. Normal
Mode displays images until the touchscreen is touched, or some other wakeup event is detected. When the device goes
back into timeout, Normal Mode will return to displaying images until the USB drive is removed from the device.
Picture View Send Command (^PIC)
The ^PIC Send Command stops either mode of Picture View, or starts Preview Mode. For more information, please
refer to the Modero X/S Series G4 Touch Panels Programming Guide, available at www.amx.com.
All images must be in JPEG format. PNG and other image formats cannot be viewed
through Picture View.
Modero X® Series G4 Touch Panels Instruction Manual
Stop
Counter
Modero X Series G4 Touch Panels
Pause/Resume
Timer
Next image
5
Advertisement
Table of Contents
