Assembly - KNOVA KN BTS-10W User Manual

ASSEMBLY

Estimated Assembly Time: 40 – 60 minutes
ASSEMBLE STAND (FIG. 1)
1. Unpack all parts and group by type and size. Refer to the
Carton Contents.
2. Attach one long top support (L) to top of leg (O) using one
bolt (1) and nut (2).
NOTE: Do not tighten bolts until stand is properly aligned (see
step # 8 before tightening).
3. Attach other end of long top support to top of another leg
using one bolt and nut.
4. Attach one long bottom support (N) to center of each leg
using bolt (1) and nut (2). This completes the front frame sec-
tion.
5. Assemble rear frame section in exactly the same manner.
6. Join front and rear frame assemblies using two short top
supports (K) and two short bottom supports (M), bolts and
nuts.
7. Insert foot pad (3) onto bottom of leg. Repeat for each leg.
8. Place stand on level surface and adjust so all legs are con-
tacting the floor and are at similar angles to the floor. Tighten
all bolts.
NOTE: Stand should not rock after all bolts are tightened.
Fig. 1
MOUNT ASSEMBLE TABLE SAW TO STAND (FIG. 1, 2)
CAUTION
Do not operate this machine directly on the floor
without using the stand. This is a very dangerous po-
sition.
1. Place cardboard or an old blanket on the floor to protect the
saw table surface.
2. Place the saw upside down on the protective material (Fig. 2).
3. Position the stand upside down on the saw base.
NOTE: Make sure front of stand (identified with label) and
front of saw are facing the same direction.
4. Line up the four holes (5) in saw base and stand.
5. Fasten saw to stand using four bolts (12), washers (13) and
nuts (14).
NOTE: Place washer on each bolt before inserting into saw
base and through the support. Nut must be positioned against
the bracket (see Fig. 1).
6. Tighten all four nuts.
NOTE: DO NOT OVERTIGHTEN NUTS HOLDING SAW TO
STAND. THIS WILL DAMAGE THE SAW BASE.
7. Carefully set the saw in its upright position on a clean
level surface.
8
Fig. 2