Assembly And Adjustments - KNOVA KN BTS-10N Manual

ASSEMBLY AND ADJUSTMENT
ASSEMBLING STAND (Fig. 1)
1. Unpack all parts and group by type and size. Refer to the
Carton Contents.
2. Attach one long top support (5) to top of leg (8) using one
bolt (1) and nut (2). Align the detents (9) in stand leg with
top supports to ensure proper fit. (Fig. 1-A)
NOTE: Do not tighten bolts until stand is properly aligned
(see step # 8 before tightening).
3. Attach other end of long top support to top of another leg
using one bolt and nut.
4. Attach one long bottom support (7) to center of each leg
using bolt (1) and nut (2). This completes the front frame
section.
5. Assemble rear frame section in exactly the same manner.
6. Join front and rear frame assemblies using two short top
supports (4) and two short bottom supports (6), bolts and
nuts.
7. Insert foot pad (3) onto bottom of leg. Repeat for each leg.
8. Place stand on level surface and adjust so all legs are
contacting the floor and are at similar angles to the floor.
Tighten all bolts using a 13 mm wrench.
NOTE: Stand should not rock after all bolts are tightened.
Fig. 1
2
5
1
7
Front
ASSEMBLING TABLE SAW TO STAND (Fig. 2)
C AUT ION
Do not operate this machine directly on
the floor without using the stand. This is a very
dangerous position.
Fig. 1-A
9
4
6
3
8
1. Place the saw (1) on the stand (2). Line up the four holes
(3) on the saw base with the holes in the stand top.
NOTE: Make sure front of stand and front of saw are facing
the same direction.
2. Fasten saw to stand using four bolts (4) and nuts (5).
3. Tighten all four nuts with two 13 mm wrenches.
NOTE: DO NOT OVERTIGHTEN NUTS HOLDING SAW TO
STAND. THIS WILL DAMAGE THE SAW BASE.
SAW MOUNTED TO WORK SURFACE (Fig. 3)
1. If the leg set will not be used, the saw must be properly
secured to a sturdy workbench using the four mounting
holes at the base of the saw.
2. The surface of the table where the saw is to be mounted
must have a hole large enough to facilitate sawdust
fall-through and removal.
3. Square the saw on the mounting surface and mark the
location of the four 3/8 in. mounting holes (1).
4. Drill 3/8 in. hole into the mounting surface.
5. Mark an 11 in. square (2) centred between the four
mounting holes (1).
6. Cut out and remove the square.
7. This opening will allow sawdust to fall through
the saw base.
8. Place the saw on the work surface, and align the mounting
holes of the saw with those drilled through the surface.
9. Fasten the saw to the work surface.
C AU T I ON
Do not operate this machine on the floor.
This is very dangerous and may cause serious injury.
9
1
Fig. 2
5
2
4
3