Accessories And Attachments; Tools Needed For Assembly; Carton Contents - KNOVA KN M-2504RC Manual

ELECTRICAL REQUIREMENTS AND SAFETY
Fig. 1

ACCESSORIES AND ATTACHMENTS

RECOMMENDED ACCESSORIES
WARNING
Visit or see the Knova Hand Tools Catalog
to purchase recommended accessories for this power
tool. 308K DADO INSERT PLATE.
WARNING
To avoid the risk of personal injury:
• Do not use adjustable (wobble) type dadoes or
carbide tipped dado blades.

TOOLS NEEDED FOR ASSEMBLY

SUPPLIED
Box-end wrench
Open-end wrench
4 mm hex wrench

CARTON CONTENTS

Separate all parts from packing materials. Check each part
with the illustration on the next page and the "Table of Loose
Parts" to make certain all items are accounted for, before
discarding any packing material.
NOTE: To make assembly easier, keep contents of box
together.
Three-pronged plug
Grounding prong
Properly grounded
three-pronged
receptacle
Grounding
• Only use stackable dadoes.
• Maximum dado width is 1/2 in.
• Do not use a dado with a diameter larger than 6 in.
• Do not use molding head set with this saw.
• Do not modify this power tool or use accessories not
recommended by Knova.
NOT SUPPLIED
Flat bladed screwdriver
Phillips screwdriver
Straight edge
WARNING
attempt to assemble the table saw, plug in the power
cord, or turn the switch ON until the missing or
damaged part is obtained and is installed correctly.
Call 01-800-70-KNOVA (56682) for missing or
damaged parts.
5
Fig. 2
lug
Adapter
Adjustable wrench and/or 5 mm,
8 mm, 10 mm, 13 mm, and
17 mm wrench
Combination square
If any part is missing or damaged, do not
Make sure this
is connected
to a known
ground.
Two-pronged
receptacle