Tools Needed For Assembly; Carton Contents - KNOVA KN M-2508RC Manual

TOOLS NEEDED FOR ASSEMBLY

SUPPLIED
Blade Wrench
Hex Key

CARTON CONTENTS

UNPACKING YOUR MITER SAW
WARNING
To avoid injury from unexpected starting
or electrical shock, do not plug the power cord into a
source of power during unpacking and assembly. This
cord must remain unplugged whenever you are working
on the saw.
1. Remove the miter saw from the carton.
IMPORTANT: Do not lift miter saw by the trigger switch
handle. It may cause misalignment. Lift machine by the
built-in carry hand hold.
2. Place the saw on a secure stationary work surface.
3. Separate all parts from the packing material. Check each
of the illustrations shown below to make certain all items
are accounted for, before discarding any packing material.
NOT SUPPLIED
Adjustable Wrench
Combination Square
Philips Screwdriver
Slotted Screwdriver
Miter Saw
COMBINATION SQUARE MUST BE TRUE
Should not gap or overlap when square is flipped over
(see dotted figure).
Draw light line on
board along this
edge.
WARNING
If any part is missing or damaged, do not attempt to
assemble the miter saw, or plug in the power cord until the
missing or damaged part is correctly replaced. To avoid
electric shock, use only identical replacement parts when
servicing double insulated tools. Call 01-800-70-KNOVA
(56682) for replacement parts.
Operator's Manual
Hold-Down
Clamp
Dust Bag
Rear Extension Stay
5
Straight edge or a 3/4 in. board,
this edge must be perfectly straight.
Gap from untrue square
when flipped over.
Miter Handle
3 mm Hex Key
Blade Wrench