Installing The Anti-Tipper - Otto Bock Motus Instructions For Use Manual

6.12 Installing the Anti-tipper (Fig. 51-53)
1. Mount the receiver tube on the frame in the position as shown in the figure (Fig. 51).
2. Screw the anti-tipper in the uppermost position of the receiver tube as shown in Fig. 52.
3. Adjust the anti‑tipper using the longitudinal adjustment (Fig. 53).
4. By changing the screw connection in the receiver tube the anti‑tipper can be horizontally adjusted.
The anti-tipper wheel must extend (at the very least) to the back edge of the rear wheel. The distance
between the wheel and ground should not exceed 5 cm maximum. Find the appropriate position with
the assistance of a helper!
26
51
53
52