Otto Bock Motus Instructions For Use Manual page 21

Adaptive wheelchair

Hide thumbs Also See for Motus:

Table of Contents

Setting the rear wheel camber to 0°: Remove the camber washer from the outside of the rear wheel

adapter and place it against the washer on the inside of the adapter such that the thinner side of the

washers is next to the thicker side of the other washer.

Once you have applied the retaining washer from the inside (Fig. 37, item B), slightly tighten the nuts on

the rear wheel fitting. Check the space between the rear wheel and the side panel. You can adjust the

space by rotating the fitting.

Toe-in correction: For toe‑in correction, loosen the nuts on the rear wheel fitting. Then also loosen

the oval head screw on the set plate (Fig. 36, item B). Now apply the bubble level (provided) to the

measuring point of the set plate and move the plate until it is level (Fig. 38). Then firmly retighten all screw

connections.

Make sure to firmly retighten all screws and nuts after making adjustments. Observe the values

INFORMATION

indicated in section 6.1.

Table of Contents