Installing The Router - Cisco 809 Hardware Installation Manual

Installing the Router

This chapter describes the equipment and the procedures for successfully installing the Cisco IR809.
Caution
Do not place anything on top of the router that weighs more than 10 pounds (4.5 kilograms), and do not stack
routers on a desktop. Excessive weight on top of the router could damage the chassis.
Caution Do not install the router or power supplies next to a heat source of any kind, including heating vents.
Warning Read the installation instructions before connecting the system to the power source. Statement 1004
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can
come into contact with such circuits. When installing the antenna, take extreme care not to come into contact
with such circuits, because they may cause serious injury or death. For proper installation and grounding of
the antenna, please refer to national and local codes (for example, U.S.:NFPA 70, National Electrical Code,
Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052
C H A P T E R
Cisco 809 Industrial Integrated Services Router Hardware Installation Guide
2
19