Readouts; Custom Settings; Service Messages; Service Utilities - Martin MAC 2000 Profile User Manual

Custom settings

The custom configuration function allows you to save and recall three sets of fixture settings. The savable settings are
DMX mode, pan/tilt speed, pan/tilt inverse and swap, DMX lamp off and reset, display settings, shortcuts, studio
mode, automatic lamp on, effects feedback, tracking algorithm, and tracking samples.

Readouts

Note: The MP-2 Uploader provides commands to display the time, temperature, and version readouts on the fixture
control panel.
Time
IN FO / TI M E
each item is a resettable (
since fabrication (
be done remotely using the MP-2 Uploader.)
Temperature
IN FO / TE M P
Firmware version
IN FO / VE R
startup.
DMX
D MX L
The

Service messages

The Service LED on the control panel lights under conditions that require fixture service, and there is a message
describing the service required. To display the message, select
when the LED is lit. There are two service messages.
Re p l ac e l a mp
HMI 1200 W/S lamp. The maximum service life is 125% of the average life, or 940 hours.
Fi xt u re o v er h ea ti n g
likely due to dirty air filters, fans, or air vents; incorrect power supply settings, or a defective fan.

Service utilities

Important! Enter must be held for several seconds to access the utilities menu.

Test sequences

T S E Q
provides a general test of all effects that can be run without a controller.
for circuit board testing that are for service use only.
Feedback toggles
An on-the-fly position correction system monitors the color wheel, gobo wheels, gobos, rotating effects, and effect
wheel. If a position error is detected, the shutter closes while the effect resets. This feature can be disabled by turning
effects feedback (
16
provides readouts of fixture hours (
R S E T ) increment counter and a non-resettable counter for total accumulated hours/strikes
T O TL
). To reset an increment counter, display it and then press [Up] until it reads 0. (This may also
provides readouts of the head and base temperature in Celsius and Fahrenheit.
displays the version number of the installed firmware. The firmware version is also displayed briefly at
menu shows the DMX start code (
is displayed when the lamp counter exceeds 750 hours, which is the rated average life for the
is displayed when the head temperature exceeds 120° C (248° F). Overheating is
U T IL / EF Fb
) off.
H RS ), lamp hours (
S T CO
) and DMX values received for each effect.
S M S G
MAC 2000 Profile
L HR ), and lamp strikes (
in the main menu. This item is available only
U T I L / P C B t
L ST ). Under
provides routines