Tailoring Performance; Information Readouts - Martin CX-10 Extreme User Manual

if they are to respond identically: they will receive the same instructions and individual control will not be
possible.
T O S E T T H E D M X A D D R E S S
1 Apply power to the CX-10. Press [menu] to enter the main menu.
2 Select AddR using the [up] and [down] keys. Press [enter].
3 Select an address (start channel) from 1 to 502 using the [up] and [down] keys. Press [enter]. Press [menu]
to return to the main menu.

Tailoring performance

M O V E M E N T
S C U T , the shortcuts setting, determines whether the color and gobo wheels scroll past open when
changing positions. When set to
the shortest path to the next position. The wheels do not scroll past open when
D I S P L A Y
The display menu (
the display remain lit, or OFF to extinguish the display two minutes after the last key press.
To flip the display for easier reading, press [up] and [down] simultaneously.
The display intensity setting (
automatic dimming of the display using the built-in light sensor, or manually select an intensity level from 10
to 100.
L A M P P O W E R
There are two settings that modify lamp control: Automatic Lamp On (
( P E RS > DL oF
There are three options for automatic lamp control:
remains off until a lamp-on command is received from the controller. When
automatically after the fixture is powered on. When
when the fixture receives DMX data, and it extinguishes automatically 15 minutes after DMX data is lost.
When ALON is either ON or DMX, lamp strike timing is determined by the fixture address to prevent all
lamps from striking at once.
The DMX Lamp-Off setting effects how the lamp can be turned off. When
switched off by sending a DMX value from 248 to 255 on channel 1 for five seconds. When
the lamp-off command will not work unless special conditions are met. Refer to the DMX protocol.
R E S E T
The fixture can be reset from the controller if DMX reset (
command will not work unless special conditions are met. Refer to the DMX protocol.
D E F A U L T S E T T I N G S
The fixture can be reset to its factory default settings by selecting

Information readouts

P O W E R - O N H O U R S
Read the total number of hours the fixture has been on since fabrication (
and the number of hours on since the counter was last reset (
used to track maintenance intervals. Press [up] for 5 seconds while displayed to reset.
10
O N , the wheels can "take a shortcut" and scroll through open when this is
) determines whether the display remains lit or not. Select
P E R S > d I S P
P E R S > d I N T
).
) controls display brightness. You can select
O N , O F F , and D M X
A L O N is set to
PE R S> d RE S
d F SE >F A CT >L O Ad .
I N FO > TI ME > HR S> R SE T
CX-10
is set to OFF.
SC U T
) and DMX Lamp-Off
PE RS > AL ON
. When A L O N is O F F
A L O N is O N , the lamp strikes
D M X , the lamp strikes automatically
d LO F is ON , lamp power can be
dL O F
) is O N . If DMX reset is
I NF O> T IM E> H RS > TO TL
). This can be
to have
O N
A U T O for
, the lamp
is ,
O F F
O FF , this
),