Readouts - Martin MAC 2000 Performance User Manual

The second parameter is the number of position updates used to calculate speed. The level is adjustable between 1 and
10 under P E R S / T R A C / C A L
calculated, making movement smoother but less responsive to sudden changes. Experiment for best results.
D I S P L A Y
The display intensity (
whether the display remains on or extinguishes two minutes after the last key-press. To flip the display, press [Up] and
[Down] simultaneously.
L A M P
There are two settings that modify lamp control: Automatic Lamp On (
When A L ON
on, the lamp strikes automatically after the fixture is powered on. When
automatically when the fixture receives DMX data, and it extinguishes 15 minutes after DMX data is lost.
A L O N
When
striking at once. The delay is determined by the fixture address.
If striking lamps from the controller, note that striking many lamps at once may cause a voltage drop large enough to
prevent lamps from striking or trip the main circuit breaker. Avoid this by programming a "lamp on" sequence that
strikes lamps one at a time at 5 second intervals.
Power to the lamp can be turned off from the controller if DMX Lamp Off (
lamp off command is executed only if position 7 is selected on the color wheel and gobo 5 is selected on both gobo
wheels. Be careful: with the magnetic ballast model, it is not possible to restrike the lamp until it has cooled for a few
minutes. (The electronic ballast model provides hot restrike.)
D M X R E S E T
The fixture can be reset from the controller if DMX reset (
command can only be executed if position 7 is selected on the color wheel and gobo 5 is selected on both gobo wheels.
C U S T O M S E T T I N G S
The custom configuration function allows you to save and recall three sets of fixture settings. The savable settings are
DMX mode, pan/tilt speed, pan/tilt inverse and swap, DMX lamp off and reset, display settings, shortcuts, studio
mode, automatic lamp on, effects feedback, tracking algorithm, and tracking samples.

Readouts

Note: The MP-2 Uploader provides commands to display the time, temperature, and version readouts on the fixture
control panel.
T I M E
IN FO / TI M E
each item is a resettable (
since fabrication (
be done remotely using the MP-2 Uploader.)
T E M P E R A T U R E
IN FO / TE M P
F I R M W A R E V E R S I O N
IN FO / VE R
startup.
. Increasing the number of samples increases the distance over which speed is
d I N T
) setting controls display brightness. The display on/off setting (
is off, the lamp remains off until a "lamp on" command is received from the controller. When
O N D M X
is set to either or
provides readouts of fixture hours (
R S E T ) increment counter and a non-resettable counter for total accumulated hours/strikes
T O TL ). To reset an increment counter, display it and then press [Up] until it reads 0. (This may also
provides readouts of the head and base temperature in Celsius and Fahrenheit.
displays the version number of the installed firmware. The firmware version is also displayed briefly at
AL ON
, the automatic lamp strike timing is staggered to prevent all lamps from
P E R S / d R E S
H RS ), lamp hours (
Control panel
d I S P
) and DMX Lamp Off ( DL oF
A L O N is set to D M X , the lamp strikes
d L O F ) is on. If d L O F
) is ON. If DMX reset is OFF, the reset
L HR ), and lamp strikes ( L ST
) determines
).
A LO N is
is off, a DMX
). Under
15