Effect Wheel - Martin MAC 2000 Profile User Manual

2 Lock the head in the upside down position and remove the bottom cover. Turn the color/gobo wheel as
required to access the desired position.
3 To remove, press the filter or gobo from the lamp side to release it. Remove from wheel.
4 To insert, work the filter or gobo under the retention spring and position it between the pins. The long edge
of the six-sided color filters must be precisely aligned with the inside of the hub in order to fit.
5 Replace the bottom cover and unlock the head before operating.

Effect wheel

The effect wheel provides two positions for rotating effects. Effects are glued into holders and are changed by
replacing the assembled effect and holder.
Replacing rotating effects
1 Disconnect the fixture from power and allow it to cool.
2 Lock the head in the upside down position and remove the bottom cover. Turn the effect wheel so that the
locking plate is under the sensor bracket.
3 To remove, hold the rim of the effect holder and pull back on the locking plate. Remove effect from wheel.
4 To insert, pull back on the locking plate. If both effects are removed, pull straight back on both tabs. Position
the groove in the effect holder over the fixed plate. Release the locking plate and verify that the effect is
properly seated.
5 Replace the bottom cover and unlock the head before operating.
Locking plate
Install filters and
gobos with
coating down,
towards the
lamp.
Figure 18: Replacing color filters and fixed gobos
Figure 19: Replacing rotating effects
Optical configuration
Position the effect holder
groove over the fixed plate.
21