GE DVSR xU User Manual page 58

54
Figure 40: The camera recording schedule submenu
4. In the Day list box select the day of the week for which you want to set the recording schedule.
5. For period 1 select the start and end recording times for that day. Select Record Type and set the
type of recording (All time, Motion, Alarm, Motion or Alarm, Motion and Alarm, or Command).
6. Repeat steps 3 and 4 for the other required time periods.
Note: The four daily time periods cannot overlap.
7. Select the schedules for the other days of the week for this camera as required.
8. When completed, select OK to confirm changes and return to the Recording menu.
To set the pre recording time for motion detection alarm and external alarm recordings
Before you set the prerecording time you must first enable the DVSR xU to respond to a motion
detection alarm (see section To setup the DVSR xU to respond to a motion detection alarm on page 40)
and/or an external alarm (see section To setup an external alarm output on page 67).
The DVSR xU is recording all the time at a defined rate. The prerecording time is the time before a
motion or external alarm is triggered and which is included in the alarm data. It is related to the bit
rate. The lower the selected bit rate, the longer the prerecording time can be.
1. In the Recording menu go to the Pre Event Time list box and select one of the time options listed
(Disabled, 30S, 25S, 20S, 15S, 10S, and 5S).
To set the post recording time for motion detection alarm and external alarm recordings
Before you set the prerecording time you must first enable the DVSR xU to respond to a motion
detection alarm (see section To setup the DVSR xU to respond to a motion detection alarm on page 40)
and/or an external alarm (see section To setup an external alarm output on page 67).
The post recording time is the time after a motion or external alarm is triggered that is included in the
alarm data.
DVSR xU User Manual