Configuring The Alarm Settings - GE DVSR xU User Manual

64
When setting up the alarm relay output, you need to set the alarm output time delay. This delay is the
time that the alarm output continues after the alarm itself has been deactivated. Consequently the
actual alarm output time consists of the alarm input time and alarm output time delay.

Configuring the alarm settings

The following procedure shows how to change the Alarm menu settings. They can be changed in any
order.
In the main menu, go to the Alarms menu icon and press Enter or left-click the mouse. The Alarms
menu appears.
To save changes made in the menu
1. When you have made all the changes required in the Alarms menu, go to OK and press Enter or
left-click the mouse to save all the changes. To abort the changes, select Cancel and press Enter.
You will then return to the main menu.
Note: Selecting OK in submenus confirms but does not save the changes made. Changes are only saved
when OK is selected in the Alarms menu.
To setup an external alarm input
1. In the Alarms menu go to the Alarm Input list box and select one of the alarm inputs listed.
2. Go to the Input Type list box and press EDIT or left-click the mouse. Depending on the sensor type,
select either NO or NC. Default is NO.
3. Select the Alarm check box and press Enter or left-click the mouse to enable () the selected
alarm input. If the alarm input is enabled, the Rules and PTZ Link setup buttons become activated.
4. To set the alarm schedule
a. In the Alarms menu go to the Rules setup button and press Enter or left-click the mouse. The
Alarm Input Rules submenu appears. See Figure 46.
DVSR xU User Manual