Aficio B2867757 Operating Instructions Manual page 45

❖ When paper does not feed in properly
Problem
Paper is not fed from
the selected tray.
Print is slanted.
Print is slanted.
Misfeeds occur
frequently.
Misfeeds occur
frequently.
Misfeeds occur
frequently.
Misfeeds occur
frequently.
Misfeeds occur
frequently.
Copy paper becomes
creased.
Copy paper becomes
creased.
There is considerable
delay between the
print start instruction
and actual printing.
There is considerable
delay between the
print start instruction
and actual printing.
There is considerable
delay between the
print start instruction
and actual printing.
Cause
When you are using a
Windows operating
system, printer driver
settings override
those set using the
display panel.
The cut paper tray's
side fences might not
be locked.
The paper is feeding
in at a slant.
The number of sheets
loaded in the cut paper
tray exceeds the capac-
ity of the machine.
The paper is damp.
The paper is too thick
or too thin.
The copy paper is
wrinkled or has been
folded/creased.
Printed paper is be-
ing used.
The paper is damp.
The paper is too thin. Use recommended paper. See "Copy Paper",
Processing time de-
pends on data vol-
ume. High volume
data, such as graph-
ics-heavy documents,
take longer to process.
The machine might
be in "Sleep mode".
The paper type set-
ting was changed.
Solution
Set the desired input tray using the printer
driver. See the printer driver Help.
Check the side fences are locked. See p.61
"Changing the Paper Size".
Load the paper correctly. See p.57 "Loading Pa-
per".
Load paper only as high as the upper limit
markings on the side fences of the cut paper
tray. See p.57 "Loading Paper".
Use paper that has been stored in the recom-
mended temperature and humidity condition.
See "Copy Paper", About This Machine.
Use recommended paper. See "Copy Paper",
About This Machine.
Use recommended paper. Use paper that has
been stored in the recommended temperature
and humidity condition. See "Copy Paper",
About This Machine.
Use recommended paper. See "Copy Paper",
About This Machine.
Use paper that has been stored in the recom-
mended temperature and humidity condition.
See "Copy Paper", About This Machine.
About This Machine.
If the data-in lamp is blinking, data has been re-
ceived by the printer. Wait for a moment.
The machine requires time to warm up if it has
been in "Sleep mode". Specify "Sleep mode" in
[System Settings], [Auto Off Timer].
If the paper type setting has been changed,
there might be a delay before printing begins.
Wait for a moment.
Other Printing Problems
3
39