Aficio B2867757 Operating Instructions Manual page 27

Problem
Image density is uneven. The original has areas of
Image density is uneven. Halftone originals can
Images are blurred when
using translucent paper.
Extreme wrinkling oc-
curs when using translu-
cent paper.
Strong wrinkles appear
when using translucent
paper.
Streaks, scratches, or
wrinkles appear in areas
of solid black.
The reverse side of an
original image is copied.
The reverse side of an
original image is copied.
Copies are blurred.
A shadow appears on
copies if you use pasted
originals.
Parts of images are not
copied.
Parts of images are not
copied.
White lines appear.
Cause
solid color, or Posi-
tive/Negative is selected
when copying multiple
sheets.
cause this problem.
Translucent paper is be-
ing used when copying
multiple sheets.
An improper paper
thickness is selected.
The paper type has re-
cently been changed
from plain paper to
translucent paper.
Copy paper has been
changed from plain to
translucent paper, or
from translucent to plain
paper.
Image density is too
high.
Auto Image Density is
not selected.
Continuous copies have
been made on small
sized paper.
Image density is too
high.
The original is not set
correctly.
The correct paper size is
not selected.
The exposure glass or
platen plate is dirty.
When You Cannot Make Clear Copies
Solution
When using Repeat Copy with originals
that have areas of solid color, set the
number of originals as follows: A0 - A2
(E - C): 1 sheet, A3 (B) or smaller: 3
sheets. For details about sizes of origi-
nals, see "Measure Chart", Copy/Docu-
ment Server Reference.
Try using "Text / Photo" or "Photo".
Select a proper paper thickness for the
copy paper. See "Tray Paper Settings",
General Settings Guide.
Select a proper paper thickness for the
copy paper. See "Tray Paper Settings",
General Settings Guide.
Wait about one minute.
After switching from plain to translu-
cent paper, wait one minute. After
switching from translucent to plain pa-
per, wait two minutes before making
copies.
Adjust the image density. See "Adjust-
ing Copy Image Density", Copy/Docu-
ment Server Reference.
Select the auto density. See "Adjusting
Copy Image Density", Copy/Document
Server Reference.
Wait about two minutes, and then try
copying again.
Adjust the image density. See "Adjust-
ing Copy Image Density", Copy/Docu-
ment Server Reference.
Change the orientation of the original.
Put mending tape on the pasted part.
Set originals correctly. See "Placing
Originals", Copy/Document Server
Reference.
Select the proper paper size.
Clean the exposure glass or platen plate.
See p.79 "Maintaining Your Machine".
2
21