De-Registration Programming By The Base - Tadiran Telecom EMERALD ICE Quick Start Manual

Hide thumbs Also See for EMERALD ICE:

Table of Contents

Emerald ICE Cordless Handset Quick Start Guide

Note:

If the user wants to register again steps 1 through 5 above

re-register to base unit.

Change the DIP SWITCH on the base changes to normal

mode - Switch-1, 2, and 3 are OFF.

Note:

The LED on the base will flash [Normally] when the unit

comes back to normal mode.

De-Registration Programming by the Base

If a user wants to de-register all handsets or remove one hand-

set only, they can perform de-registration the handset by the

base unit. The handset unit must be moved to a position near

the Base Unit to receive a de-registration command. After de-

registration, the handset unit won't link with the base any more.

There are 2 ways to de-register the handset unit.

Operation Procedure for Method-A (Using the base only):

De-register all handsets

Turn DIP SWITCH-1, SWITCH-2 to ON and turn off-

SWITCH-3 to OFF.

After 5 seconds, the system will de-register all handsets.

Page 2-4

Table of Contents

Do you have a question about the EMERALD ICE and is the answer not in the manual?