Function Buttons - Janome Memory Craft 5200 Instruction Manual

r
e
w
q
t

Function Buttons

q q q q q Start/stop button
Press this button to start or stop the machine. The machine starts
running slowly for the first few stitches, it then runs at the speed
set by the speed control slider.
NOTE:
• Start/stop button cannot be used when the foot control is
connected to the machine.
• If you start the machine with the presser foot up, a warning
message will appear to advise you to lower the foot.
Lower the foot and rstart the machine again.
t Warning message
w w w w w Reverse stitch button
When stitches
are selected, the machine will sew in reverse while the reverse
stitch button is pressed.
If you press the reverse stitch button when sewing any other
stitches, the machine will immediately sew locking stitches and
automatically stop.
e e e e e Auto-lock button
When stitches
are selected, the machine will immediately sew locking stitches
when the Auto-lock button is pressed, then automatically stop.
When sewing any other stitches, the machine will sew locking
stitches at the end of the current pattern and automatically stop.
r r r r r Up/down needle position button
Press this button to bring the needle up or down. The machine
will stop with the needle up or down depending on the needle
position determined by this button.
NOTE:
The needle will always stop in the up position after
sewing buttonholes, bartacks, eyelets and darning.
7
(mode 1)
(mode 1)
(mode 2)
(mode 2)