Janome Memory Craft 5200 Instruction Manual page 52

q
w
e
To sew a shorter darning
To sew a darning shorter than 2 cm (3/4˝), first stop the
machine after sewing the required length, then press the
reverse button.
The required length has been determined.
Start the machine again and continue sewing until the
machine stops automatically.
q Required length
w Starting point
e Reverse stitch button
To sew the same size darning
Simply start the machine to sew another darning at the
same size.
To sew the darning at a different size
Press the memory button and start sewing from the
beginning.
To adjust the evenness of darning
The evenness of darning may vary depending on the
sewing conditions, such as type of fabrics, number of
layers etc. You can correct the unevenness of darning with
the stitch length adjustment button.
If the left corner is lower than the right side, press "–" to
correct it.
If the right corner is lower than the left side, press "+" to
correct it.
NOTE:
The evenness can be adjusted within d1 to d9 (default
setting is d5).
50