Button Sewing - Janome Memory Craft 5200 Instruction Manual

q
e
w
q
q
e
w
w
e

Button Sewing

q Pattern:
w Presser foot:
e Thread tension:
r Feed dog:
Attaching the button sewing foot T
Insert the rear pin on the foot into the groove of the foot
holder.
Gently lower the presser foot lifter while holding the foot
with your fingers.
q Rear pin
w Groove of the foot holder.
To sew
Place a button on the fabric and lower the needle by
turning the hand wheel with your hand, so that the
needle enters through the left hole in the button.
Align the direction of button and lower the button sewing
foot T to hold the button in place.
Press the up/down needle button to bring the needle up
to the highest position. Adjust the stitch width, so that the
zigzag width matches the span of holes in the button.
Press the start/stop button to sew and the machine will
stop automatically.
Cut the needle thread at the beginning.
q Needle thread at the beginning
Pull the bobbin thread to pull the needle thread to the
wrong side off the fabric.
w Needle thread
e Bobbin thread
Tie both threads together.
* Raise the feed dog after sewing.
39
#23 (mode 2)
Button sewing foot T
AUTO
Lowered