Function Buttons & Lcd Display - Janome DC6030 Instruction Book

!2
y
!1
!3
r
w
e
o
i
u
!0
q
Function Buttons & LCD Display
q q q q q Pattern selection buttons
Press the pattern selection button to select the desired
pattern.
A pattern number and pattern image along with an
identification letter of the recommended foot are
!4
indicated on each button.
When the pattern is selected a green light on the button
will turn on.
t
u Green light
i Stitch image
o Pattern number
!0 Recommended foot
w w w w w Elongation button
Satin stiches, patterns 21, 22 and 23 can be elongated
up to five times their normal length by pressing the
elongation button. Refer to page 45.
e e e e e Twin needle button
Press this button when using a twin needle.
The twin needle mark will appear and the maximum
stitch width will be limited to 3.0.
To cancel or finish the twin needle sewing, press the
twin needle button twice.
NOTE:
When the twin needle mark is blinking, all the other
buttons and buttons will not respond. Press the twin
needle button again.
For twin needle sewing, refer to pages 46, 47.
r r r r r Stitch width adjusting button
Press "+" or "–" to change the stitch width. Refer to
pages 22, 25 and 31.
t t t t t Stitch length adjusting button
Press "+" or "–" to change the stitch length. Refer to
pages 22, 25 and 31.
y y y y y
LCD Display
The LCD display shows the following information when
the machine is turned on:
!1 Pattern number
!2 Recommended presser foot
!3 Stitch width
!4 Stitch length
7