Step 18. Install Batteries - MacDon M Series Unloading And Assembly Instructions

STEP 18. INSTALL BATTERIES

A. M150, M200
a. Open the hood at the lowest position as follows:
B
A
1. Locate latch (A) behind grill, and lift to release
hood.
2. Raise hood until strap (B), which should be
looped under hooks (C), stops it at
approximately a 40° angle.
b. Check battery disconnect switch (D) is turned off.
c. Open right hand (cab-forward) maintenance
platform.
d. Remove cable ties securing battery clamps and
cables to frame.
Form 169242
UNLOADING AND ASSEMBLY
C
D
J
F
e. Position new batteries on holder (E), with positive
posts closest to platform.
RATING GROUP CCA VOLT
Heavy
Duty,
Off-Road, BCI 31A
Vibration
Resistant
f. Install strap (F) with bolts (G) provided and tighten
securely
BATTERY IS NEGATIVE GROUNDED.
Always connect starter cable to the
positive (+) terminal of battery and
battery ground cable to negative (-)
terminal of battery. Reversed polarity in
battery or alternator may result in
permanent
system.
g. Attach positive (red) cable clamps (J) to positive
post on batteries and tighten. Reposition plastic
covers onto clamps.
h. Attach negative (black) cable clamps (H) to
negative post on batteries and tighten clamps.
i. Move platform back to closed position.
j. Close engine compartment hood.
37
G
G
MAX. DIMENSION
13 x 6.81 x 9.44 in.
750 12
(330 x 173 x 240 mm)
IMPORTANT
damage to electrical
Revision D
H
E